#3 not meant to be...but more started.

#3 goes down in a flame of glory. Shaping grind, jimped and filework.... HT, tempering....
Getting ready to start the final grind and then it happened.
A slip in consintration and a slip out of the hand...

Determined to put it out of my mind, I started on 3 more. A little different shaping on these. I also decided to shorten the cutting edge on 2 of them. The overall length of the razor is the same as any other but on 2 the cuting edge will only be 2.5". The other will be the more common 2 3/4".
Hoping to be a little more careful  this time...